jeudi 15 janvier 2009

Dagerboard cage

Le puits de dérive...

Plywood 6 mm on both sides. Note that I covered the inside with fiber glass, to avoid premature wood wear.

The holes for the shaft must be drilled before to install the frame in the boat, as the access inside the boat is very limited on both sides once in place.

Once all the boat chines are covered with fiber glass, you can remove the center frame, it was there temporarily only.

Then you cut the frame into two pieces and glue it together with the dagerboard cage. The hull will be cut off later.

Aucun commentaire:

Enregistrer un commentaire